Bahay> Blog> LM 80 Test Report for White LED

LM 80 Test Report for White LED

March 27, 2019

Best LED factory - LM80 Test Report


LM-80 is a standard which created by Illuminating Engineering Society of North America (IESNA) to measure time-dependent lumen loss. LED and lighting manufacturers are performed proper tests in order to determine the performance of the products over time.

LM-80 test can be applied to the LED package, series or modules. It can not be applied to the whole system. In other words, it cannot be applied to entire light fixture.

Normally this test just for white SMD LED (2835 SMD LED type, 5050 SMD LED type,  5730 SMD LED type ect.) or white through-hole LED(5mm LED type, 3mm LED, 8mm LED or 10mm LED type). 


LED technology has longer life span according to previous lighting technologies. However, LEDs tend to gradually deteriorate during the time they are used. This deterioration can be seen as decrease in light output.


LM-80 standard is accepted in many countries around the world. LM-80 and other similar tests are intended to test LED and LED devices in several standard operating conditions.

The LM-80 test should be maintained for a minimum of 6,000 hours, preferably for 10,000 hours. Measurement range should be considered as maximum of 1.000 hours. Light flux (lumen) should be measured in three different temperatures that are; 55°C, 85°C and the third temperature which is designated by the manufacturer.

Light output-hour graphic is generated for specified LED driver as a result of the LM-80 test. There are different curves for different heat values. This graphic shows the time-dependent change in the LED’s light output.

LM-80 report contains; information about the light source, environmental conditions, electrical conditions, heat values, lumen values and colorimetric shift over time. LM-80 does not include any method for calculation of life span of a product. TM-21 standard must be used for this calculation.

LM-80 test usually performed by LED manufacturers and the report on the test result is shared with the product technical data. LM-80 test must be performed in accredited laboratory.

Lighting manufacturers and designers have used this standardized data when making led choices. LM-80 report is very important for both LED manufacturers and lighting manufacturers.

Makipag-ugnayan sa amin

Author:

Ms. ZhangFuqin

Phone/WhatsApp:

+8615815584344

Mga Popular na Produkto
You may also like
Related Categories

Mag-email sa supplier na ito

Paksa:
Email:
Mensahe:

Your message must be betwwen 20-8000 characters

Makipag-ugnayan sa amin

Author:

Ms. ZhangFuqin

Phone/WhatsApp:

+8615815584344

Mga Popular na Produkto
Makikipag -ugnay kami sa iyo kaagad

Punan ang karagdagang impormasyon upang makapag -ugnay sa iyo nang mas mabilis

Pahayag ng Pagkapribado: Napakahalaga sa amin ng iyong privacy. Nangako ang aming kumpanya na huwag ibunyag ang iyong personal na impormasyon sa anumang paglawak sa iyong tahasang mga pahintulot.

Ipadala